Car came in for an issue that car would not go into gear when cold, when it got hot it seemed to slowly go into gear. Inspected wiring system for F1 sensor found it to be ok, check input shaft sensor and not getting any reading from it, also removed bell housing to inspect travel of t/o bearing and found that t/o bearing to be stuck on shaft. Removed bearing and found broken seal, it was stuck between t/o bearing and shaft. Installing new clutch, F1 sensor and new seals. Will also bleed F1 system and perform self learning procedure. Once all parts replaced, we will also perform roadt test to make sure that vehicle now shifts at all times.
0 comments:
Post a Comment